No products were found matching your selection.
Other Related Products
-
Protective film for painted sheet goods should be selected around the full processing route, not from film thickness or initial tack alone. Pre-painted steel, coated aluminum, PCM/VCM panels, roofing sheet, cladding and other finished metal can be exposed to scratches, trapped particles, edge lifting, wrinkles, adhesive transfer and visible surface marking during slitting, punching, bending, roll forming, stamping, storage and shipment. A reliable approval plan starts with the actual coating and finish, then checks application conditions, deformation severity, dwell time and removal stage. Sample testing and a production-representative trial are recommended before full use.
-
- Material: Clear PET polyester film
- Surface: Printable receiving coating
- Finish: Clear, semi-matte, or matte
- Thickness: 50um, 75um, 100um typical
- Roll Core: 3 inch or 6 inch core
- Use: Sublimation printing and transfer testing
-
Carpet protection during construction should be managed as a jobsite process, not a simple covering task. It applies when installed carpet remains during fit-out, painting, punch-list work, furniture installation, or repeated trade traffic. Key risks are embedded grit, spills, edge lifting, wrinkles, puncture, adhesion growth, adhesive transfer, and fiber disturbance. Selection should reflect carpet construction, cleanliness, traffic, planned dwell, environment, application method, and an actual-carpet trial.
-
- Material: PE protective film
- Color: Clear, blue, black & white
- Thickness: 40 / 50 / 60 / 70 / 80 microns
- Adhesive: Water-based acrylic
- Width: 100–1240 mm
- Surface Match: Gloss, semi-gloss, smooth, lightly textured
-
- Material: PE protective film
- Thickness: 30 / 40 / 50 / 60 / 80 microns
- Colors: Clear, blue, black & white
- Adhesion: Low, medium, or high
- Roll Width: Custom slit widths available
- Surface Finish: 2B, BA, mirror, brushed, No.4, hairline
-
- Product Type: Optical-grade OCA bonding film
- Adhesive Layer: Clear double sided adhesive layer
- Common Thickness: 50um, 100um, 125um, 175um, 250um
- Appearance: Transparent, low haze, high clarity
- Liner: PET release liner, easy release and tight release options
- Main Use: Display bonding, glass bonding, optical component assembly
-
PET film puncture resistance describes how a defined PET or PET-based construction responds to localized penetration. This technical data compares puncture force, penetration distance, energy, and failure behavior for bare, treated, coated, and adhesive-backed PET films. Results support grade or lot comparison only when the tested structure, probe setup, and conditions are identified. Sample testing remains necessary before full use.
-
- Material: PE film
- Adhesive: removable self-adhesive coating
- Common Colors: blue, clear, printed
- Common Widths: 24 in, 36 in, 48 in, 600 mm
- Common Roll Lengths: 200 ft, 500 ft, custom
- Typical Use: temporary protection for sealed hard floors
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
