No products were found matching your selection.
Other Related Products
-
- Thickness: 250um / 0.25mm for rigid support parts
- Material: PET polyester film with insulating properties
- Color Options: Clear, translucent, milky white, black or custom color
- Surface: Smooth, flat surface with low-curl control
- Processing: Slitting, sheeting, punching, cutting and die-cutting
- Main Uses: Insulation gasket, spacer layer, washer and panel backing
-
- Material: Chemical coated BOPET / PET film
- Color: Clear transparent
- Coating side: One-side, two-side, or coated plus corona treated
- Thickness: 12-250 um
- Supply form: Jumbo roll, slit roll, or sheet
- Uses: Printing, coating, lamination, metallizing, label stock
-
- Material: APET / RPET
- Color: clear, translucent, tinted
- Surface: glossy, smooth
- Supply form: roll stock
- Thickness: custom production range
- Typical use: thermoforming and packaging conversion
-
- Material: PET material / polyester film
- Common thickness: 25 um-250 um
- Color: clear, matte, translucent, milky white
- Surface: untreated, corona treated, primer treated
- Processing: insulation, printing, lamination, die cutting
- Key properties: thermal stability, dimensional stability
-
- Material: PET film with double side silicone coating
- Typical Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Color Options: Clear, milky white, blue, red, or matte finish
- Release Design: Equal release or differential release liner
- Common Width: 300-1600 mm, slit roll available
- Main Use: Tape, label stock, foam tape, and die-cut liner
-
- Common width: 1040 mm, 1270 mm, or custom slit width
- Material: PET, TPU, or multilayer functional film
- Surface: clear, matte, privacy, anti-glare, anti-fingerprint
- Supply type: jumbo roll, slit roll, converting roll stock
- Use range: phone, tablet, watch, laptop, display panel
- Processing: die cutting, plotter cutting, laser cutting
-
- Material: PE protective film
- Thickness: 30 / 40 / 50 / 60 / 80 microns
- Colors: Clear, blue, black & white
- Adhesion: Low, medium, or high
- Roll Width: Custom slit widths available
- Surface Finish: 2B, BA, mirror, brushed, No.4, hairline
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
- Material: PE film
- Adhesive: acrylic-based
- Colors: clear, blue, white, black & white
- Thickness: 30–80 mic typical
- Width: 1000–1500 mm common
- Use: processing to installation
