No products were found matching your selection.
Other Related Products
-
Polyester film chemical resistance depends on the tested film construction, chemical concentration, contact temperature, exposure time, and applied stress. This technical data supports bare BOPET, surface-treated PET, and adhesive-backed protective film used on glass, metal, plastic, painted, or coated surfaces. Reference values help define a test plan, while the actual chemical, surface, dwell period, and removal behavior should be confirmed through representative sample testing before full use.
-
- Material: PE surface protection film
- Adhesive: acrylic-based or rubber-based
- Color options: clear, blue, black/white, custom print
- Thickness range: 30–120 microns
- Roll width: up to 3200 mm
- Surface fit: gloss, matte, satin, and lightly textured coatings
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
- Material: Chemical coated BOPET / PET film
- Color: Clear transparent
- Coating side: One-side, two-side, or coated plus corona treated
- Thickness: 12-250 um
- Supply form: Jumbo roll, slit roll, or sheet
- Uses: Printing, coating, lamination, metallizing, label stock
-
- Material: PE film
- Adhesive: acrylic-based
- Colors: clear, blue, white, black & white
- Thickness: 30–80 mic typical
- Width: 1000–1500 mm common
- Use: processing to installation
-
- Material: Clear PET polyester film
- Surface: Printable receiving coating
- Finish: Clear, semi-matte, or matte
- Thickness: 50um, 75um, 100um typical
- Roll Core: 3 inch or 6 inch core
- Use: Sublimation printing and transfer testing
-
Protective film for painted sheet goods should be selected around the full processing route, not from film thickness or initial tack alone. Pre-painted steel, coated aluminum, PCM/VCM panels, roofing sheet, cladding and other finished metal can be exposed to scratches, trapped particles, edge lifting, wrinkles, adhesive transfer and visible surface marking during slitting, punching, bending, roll forming, stamping, storage and shipment. A reliable approval plan starts with the actual coating and finish, then checks application conditions, deformation severity, dwell time and removal stage. Sample testing and a production-representative trial are recommended before full use.
-
- Material:Red transparent PET film or red transparent PVC film
- Color Density:Light red, standard red, deep red, or sample-matched tone
- Thickness:PET 25 um – 250 um / PVC 100 um – 500 um typical
- Light Transmission:Light red 55% – 78% / deep red 18% – 45% typical
- Surface:Smooth roll surface for printing, lamination, slitting, or die-cutting
- Uses:Packaging window, lighting filter, display overlay, LED window, visual identification
-
- Material: PE protective film
- Color: Clear, blue, black & white
- Thickness: 40 / 50 / 60 / 70 / 80 microns
- Adhesive: Water-based acrylic
- Width: 100–1240 mm
- Surface Match: Gloss, semi-gloss, smooth, lightly textured
