No products were found matching your selection.
Other Related Products
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
- Thickness: 250um / 0.25mm for rigid support parts
- Material: PET polyester film with insulating properties
- Color Options: Clear, translucent, milky white, black or custom color
- Surface: Smooth, flat surface with low-curl control
- Processing: Slitting, sheeting, punching, cutting and die-cutting
- Main Uses: Insulation gasket, spacer layer, washer and panel backing
-
- Material: clear PET / BOPET polyester film
- Color: transparent clear, light tint by request
- Thickness: 25-250um typical factory range
- Function: anti static surface charge control
- Supply form: slit roll or cut sheet
- Use: electronic, optical, and clean converting
-
PET film puncture resistance describes how a defined PET or PET-based construction responds to localized penetration. This technical data compares puncture force, penetration distance, energy, and failure behavior for bare, treated, coated, and adhesive-backed PET films. Results support grade or lot comparison only when the tested structure, probe setup, and conditions are identified. Sample testing remains necessary before full use.
-
- Material: clear PET film
- Structure: PET with PSA
- Color: clear or light anti-glare
- Thickness: 25-125 um PET base
- Supply: rolls or slit rolls
- Use: printed and display surfaces
-
- Material: Clear PET film with non-silicone release coating
- Release side: Single side release surface
- Color: Transparent or light haze visual grade
- Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Supply form: Clear release film roll or sheet supply
- Typical use: Electronics adhesive release liner, clean interleaf, transparent laminate support
-
- Material: Clear PET polyester film
- Surface: Printable receiving coating
- Finish: Clear, semi-matte, or matte
- Thickness: 50um, 75um, 100um typical
- Roll Core: 3 inch or 6 inch core
- Use: Sublimation printing and transfer testing
-
- Material: PE protective film
- Adhesive: Acrylic pressure-sensitive adhesive
- Colors: Blue, clear, white, black/white
- Thickness: 40–100 microns
- Width: 25–1250 mm
- Surfaces: Anodized, powder-coated, painted, and smooth aluminium
-
- Material: PE film
- Adhesive: removable self-adhesive coating
- Common Colors: blue, clear, printed
- Common Widths: 24 in, 36 in, 48 in, 600 mm
- Common Roll Lengths: 200 ft, 500 ft, custom
- Typical Use: temporary protection for sealed hard floors
