No products were found matching your selection.
Other Related Products
-
- Material: PET polyester film
- Thickness: custom industrial gauges
- Roll type: jumbo roll, master roll, slit roll
- Surface: untreated, single corona, double corona
- Finish: clear, white, black, matte, gloss
- Processing: slitting, rewinding, sheeting
-
- Material: PE or PET-based
- Color: Clear, blue, or milky white
- Adhesion: Low to medium tack
- Thickness: 30–100 microns
- Supply Form: Roll, sheet, slit roll, or die-cut
- Use Stage: Printing to final assembly
-
- Thickness:125um / 0.125mm / 5 mil
- Material:Biaxially oriented PET film
- Surface:Clear, matte, treated, or coating-ready
- Format:Roll, slit roll, or sheet
- Processing:Printing, lamination, punching, die cutting
- Use:Overlay, insulation, spacer, carrier layer
-
- Material: PET film with double side silicone coating
- Typical Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Color Options: Clear, milky white, blue, red, or matte finish
- Release Design: Equal release or differential release liner
- Common Width: 300-1600 mm, slit roll available
- Main Use: Tape, label stock, foam tape, and die-cut liner
-
- Common widths:24 in, 36 in, 48 in, or custom roll width
- Common length:200 ft per roll, custom length available
- Film material:PE / LDPE temporary closure film
- Adhesive:water-based acrylic adhesive, medium tack or high tack
- Color options:blue for visibility, clear for inspection
- Use area:open ductwork, air duct, vent opening, and HVAC fixture protection
-
Protective lens film for spray booths is used as a replaceable transparent layer over a viewing window so paint overspray, dry spray, dust, and routine wiping contact the film before they reach the clear substrate. This guide is intended for glass, coated glass, acrylic, and polycarbonate observation panels used in automotive refinishing and industrial coating areas. The main risks are reduced visibility, trapped contamination, edge lifting, adhesive transfer, film tearing, and an unverified removal interval. Selection should be based on the actual window material, coating condition, optical requirement, booth temperature, cleaning method, vertical holding need, and a sample test that continues through the planned service period.
-
- Material: PET polyester film with pressure-sensitive adhesive
- Typical film thickness: 25 / 36 / 50 / 75 / 100 microns
- Adhesive options: acrylic or silicone
- Color options: clear, blue, milky, matte black, or custom
- Supply form: log rolls, slit rolls, sheets, or die-cut pieces
- Common uses: insulation, masking, surface protection, lamination, and converting
-
- Product Type: Optical-grade OCA bonding film
- Adhesive Layer: Clear double sided adhesive layer
- Common Thickness: 50um, 100um, 125um, 175um, 250um
- Appearance: Transparent, low haze, high clarity
- Liner: PET release liner, easy release and tight release options
- Main Use: Display bonding, glass bonding, optical component assembly
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
