No products were found matching your selection.
Other Related Products
-
Carpet protection during construction should be managed as a jobsite process, not a simple covering task. It applies when installed carpet remains during fit-out, painting, punch-list work, furniture installation, or repeated trade traffic. Key risks are embedded grit, spills, edge lifting, wrinkles, puncture, adhesion growth, adhesive transfer, and fiber disturbance. Selection should reflect carpet construction, cleanliness, traffic, planned dwell, environment, application method, and an actual-carpet trial.
-
- Material: Clear PET polyester film
- Surface: Printable receiving coating
- Finish: Clear, semi-matte, or matte
- Thickness: 50um, 75um, 100um typical
- Roll Core: 3 inch or 6 inch core
- Use: Sublimation printing and transfer testing
-
- Material: PET film with double side silicone coating
- Typical Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Color Options: Clear, milky white, blue, red, or matte finish
- Release Design: Equal release or differential release liner
- Common Width: 300-1600 mm, slit roll available
- Main Use: Tape, label stock, foam tape, and die-cut liner
-
- Material: PVC decorative vinyl with adhesive backing
- Finish: wood grain, matte, gloss, high gloss, solid color
- Width: 600mm, 1220mm, 1240mm, or custom
- Roll length: 30m, 50m, 100m, or bulk roll
- Surfaces: sealed MDF, laminated board, plywood, painted furniture panels
- Supply: roll, cut sheet, sample swatch, color-matched batch
-
- Common widths: 500 mm-1500 mm rolls
- Color options: blue, white, clear, black
- Base material: flame-retardant PE film
- Surface type: smooth or anti-slip embossed
- Thickness range: 80-1000 um
- Main use: temporary site surface covering
-
- Material: Clear PET carrier
- Thickness: 50um, 75um, 100um
- Finish: Matte, semi-matte, glossy
- Peel type: Hot peel, cold peel
- Use: Textile logo transfer
- Supply: Rolls or sheets
-
- Thickness: 250um / 0.25mm for rigid support parts
- Material: PET polyester film with insulating properties
- Color Options: Clear, translucent, milky white, black or custom color
- Surface: Smooth, flat surface with low-curl control
- Processing: Slitting, sheeting, punching, cutting and die-cutting
- Main Uses: Insulation gasket, spacer layer, washer and panel backing
-
- Material: PE protective film
- Color: Clear, blue, black & white
- Thickness: 40 / 50 / 60 / 70 / 80 microns
- Adhesive: Water-based acrylic
- Width: 100–1240 mm
- Surface Match: Gloss, semi-gloss, smooth, lightly textured
-
Protective lens film for spray booths is used as a replaceable transparent layer over a viewing window so paint overspray, dry spray, dust, and routine wiping contact the film before they reach the clear substrate. This guide is intended for glass, coated glass, acrylic, and polycarbonate observation panels used in automotive refinishing and industrial coating areas. The main risks are reduced visibility, trapped contamination, edge lifting, adhesive transfer, film tearing, and an unverified removal interval. Selection should be based on the actual window material, coating condition, optical requirement, booth temperature, cleaning method, vertical holding need, and a sample test that continues through the planned service period.
