No products were found matching your selection.
Other Related Products
-
- Material: PET polyester film with pressure-sensitive adhesive
- Typical film thickness: 25 / 36 / 50 / 75 / 100 microns
- Adhesive options: acrylic or silicone
- Color options: clear, blue, milky, matte black, or custom
- Supply form: log rolls, slit rolls, sheets, or die-cut pieces
- Common uses: insulation, masking, surface protection, lamination, and converting
-
- Material: PE film with removable adhesive
- Color: Black/white, transparent, blue, or printed
- Thickness: Typical 60-100 um
- Adhesion: 1.8-5.5 N/25 mm typical range
- Roll format: Slit rolls for sheet lamination
- Suitable surface: Stainless steel, coated metal, aluminum sheet
-
- Material: PE or polyolefin forming-grade film
- Thickness: 50 um-100 um typical
- Color: Blue, clear, white, or black-white
- Adhesive: Removable acrylic or rubber-based adhesive
- Process: Deep drawing, stamping, forming
- Use: Metal sheet, appliance, automotive, kitchenware parts
-
- Common widths: 500 mm-1500 mm rolls
- Color options: blue, white, clear, black
- Base material: flame-retardant PE film
- Surface type: smooth or anti-slip embossed
- Thickness range: 80-1000 um
- Main use: temporary site surface covering
-
- Material: PE protective film
- Color: Clear, blue, black & white
- Thickness: 40 / 50 / 60 / 70 / 80 microns
- Adhesive: Water-based acrylic
- Width: 100–1240 mm
- Surface Match: Gloss, semi-gloss, smooth, lightly textured
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
- Material: Clear PET carrier
- Thickness: 50um, 75um, 100um
- Finish: Matte, semi-matte, glossy
- Peel type: Hot peel, cold peel
- Use: Textile logo transfer
- Supply: Rolls or sheets
-
- Common widths:24 in, 36 in, 48 in, or custom roll width
- Common length:200 ft per roll, custom length available
- Film material:PE / LDPE temporary closure film
- Adhesive:water-based acrylic adhesive, medium tack or high tack
- Color options:blue for visibility, clear for inspection
- Use area:open ductwork, air duct, vent opening, and HVAC fixture protection
-
Carpet protection during construction should be managed as a jobsite process, not a simple covering task. It applies when installed carpet remains during fit-out, painting, punch-list work, furniture installation, or repeated trade traffic. Key risks are embedded grit, spills, edge lifting, wrinkles, puncture, adhesion growth, adhesive transfer, and fiber disturbance. Selection should reflect carpet construction, cleanliness, traffic, planned dwell, environment, application method, and an actual-carpet trial.
