No products were found matching your selection.
Other Related Products
-
- Material: PE film with pressure-sensitive adhesive
- Adhesion: Low tack, medium tack, or custom
- Color: Clear, blue, or milky translucent
- Thickness: Standard and custom options
- Width: Slit rolls and sheet sizes
- Use: Temporary screen protection
-
- Material: PE film
- Adhesive: acrylic-based
- Colors: clear, blue, white, black & white
- Thickness: 30–80 mic typical
- Width: 1000–1500 mm common
- Use: processing to installation
-
- Material: PE film with removable adhesive
- Color: Clear, blue, white, black-white, or printed
- Thickness: 30-100 um, typical factory test range
- Adhesive: Low or medium tack pressure-sensitive adhesive
- Width: Custom slit width, +/-1 mm typical tolerance
- Surface Use: Stainless steel, PCM/VCM, glass, and plastic panels
-
- Common widths:24 in, 36 in, 48 in, or custom roll width
- Common length:200 ft per roll, custom length available
- Film material:PE / LDPE temporary closure film
- Adhesive:water-based acrylic adhesive, medium tack or high tack
- Color options:blue for visibility, clear for inspection
- Use area:open ductwork, air duct, vent opening, and HVAC fixture protection
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
PET film puncture resistance describes how a defined PET or PET-based construction responds to localized penetration. This technical data compares puncture force, penetration distance, energy, and failure behavior for bare, treated, coated, and adhesive-backed PET films. Results support grade or lot comparison only when the tested structure, probe setup, and conditions are identified. Sample testing remains necessary before full use.
-
- Thickness: 100um / 0.1mm / approx. 4 mil
- Material: PET polyester film roll
- Color: Clear standard, other finishes on request
- Surface: Untreated, one-side corona, or two-side corona
- Roll format: Custom width, length, 76mm or 152mm core ID, roll OD
- Uses: Die-cutting, insulation parts, labels, adhesive coating, lamination
-
- Material: PET film
- Finish: clear gloss / matte / anti-glare
- Typical thickness: 100–250 microns
- Surface option: hard coat / anti-fingerprint
- Supply form: rolls, sheets, die-cut pieces
- Adhesive option: removable or application-matched adhesive
-
Carpet protection during construction should be managed as a jobsite process, not a simple covering task. It applies when installed carpet remains during fit-out, painting, punch-list work, furniture installation, or repeated trade traffic. Key risks are embedded grit, spills, edge lifting, wrinkles, puncture, adhesion growth, adhesive transfer, and fiber disturbance. Selection should reflect carpet construction, cleanliness, traffic, planned dwell, environment, application method, and an actual-carpet trial.
