No products were found matching your selection.
Other Related Products
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Thickness: 30–150 microns
- Colors: clear, blue, white, black-and-white
- Width: up to 2000 mm
- Surface fit: glossy, matte, textured, coated sheets
-
- Thickness: 250um / 0.25mm for rigid support parts
- Material: PET polyester film with insulating properties
- Color Options: Clear, translucent, milky white, black or custom color
- Surface: Smooth, flat surface with low-curl control
- Processing: Slitting, sheeting, punching, cutting and die-cutting
- Main Uses: Insulation gasket, spacer layer, washer and panel backing
-
Laser cutting stainless steel with film is most reliable when the protective layer, stainless steel finish, lamination method, laser process, part geometry, and removal timing are validated as one system. This guide addresses bubbling at pierce points, lifting along cut paths, film shrinkage, surface contamination, scratches, adhesive transfer, and difficult removal on 2B, BA, mirror, brushed, hairline, and coated stainless steel. It is intended for sheet-metal processing where the film remains on the plate during cutting and may continue through bending, stacking, storage, or transport. The main acceptance test is a production-representative trial on the actual surface, machine, and removal schedule.
-
- Material: APET / RPET
- Color: clear, translucent, tinted
- Surface: glossy, smooth
- Supply form: roll stock
- Thickness: custom production range
- Typical use: thermoforming and packaging conversion
-
- Common widths: 500 mm-1500 mm rolls
- Color options: blue, white, clear, black
- Base material: flame-retardant PE film
- Surface type: smooth or anti-slip embossed
- Thickness range: 80-1000 um
- Main use: temporary site surface covering
-
- Material: PET film with double side silicone coating
- Typical Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Color Options: Clear, milky white, blue, red, or matte finish
- Release Design: Equal release or differential release liner
- Common Width: 300-1600 mm, slit roll available
- Main Use: Tape, label stock, foam tape, and die-cut liner
-
Carpet protection during construction should be managed as a jobsite process, not a simple covering task. It applies when installed carpet remains during fit-out, painting, punch-list work, furniture installation, or repeated trade traffic. Key risks are embedded grit, spills, edge lifting, wrinkles, puncture, adhesion growth, adhesive transfer, and fiber disturbance. Selection should reflect carpet construction, cleanliness, traffic, planned dwell, environment, application method, and an actual-carpet trial.
-
- Material: PE film with pressure-sensitive adhesive
- Thickness: 40–80 microns typical
- Width Range: 50–1240 mm
- Length Range: 100–500 m
- Colors: Clear, blue, translucent
- Suitable Surfaces: Float glass, tempered glass, laminated glass, mirror, and selected coated glass
-
- Common widths:24 in, 36 in, 48 in, or custom roll width
- Common length:200 ft per roll, custom length available
- Film material:PE / LDPE temporary closure film
- Adhesive:water-based acrylic adhesive, medium tack or high tack
- Color options:blue for visibility, clear for inspection
- Use area:open ductwork, air duct, vent opening, and HVAC fixture protection
