No products were found matching your selection.
Other Related Products
-
- Material: PE film with removable adhesive
- Color: Black/white, transparent, blue, or printed
- Thickness: Typical 60-100 um
- Adhesion: 1.8-5.5 N/25 mm typical range
- Roll format: Slit rolls for sheet lamination
- Suitable surface: Stainless steel, coated metal, aluminum sheet
-
- Material: Clear PET film with non-silicone release coating
- Release side: Single side release surface
- Color: Transparent or light haze visual grade
- Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Supply form: Clear release film roll or sheet supply
- Typical use: Electronics adhesive release liner, clean interleaf, transparent laminate support
-
- Material: PE protective film
- Adhesive: acrylic pressure-sensitive adhesive
- Thickness: 30–150 microns
- Colors: clear, blue, white, black-and-white
- Width: up to 2000 mm
- Surface fit: glossy, matte, textured, coated sheets
-
- Material: clear PET film
- Structure: PET with PSA
- Color: clear or light anti-glare
- Thickness: 25-125 um PET base
- Supply: rolls or slit rolls
- Use: printed and display surfaces
-
- Material: PE protective film
- Thickness: 30 / 40 / 50 / 60 / 80 microns
- Colors: Clear, blue, black & white
- Adhesion: Low, medium, or high
- Roll Width: Custom slit widths available
- Surface Finish: 2B, BA, mirror, brushed, No.4, hairline
-
- Material: PE film with removable adhesive
- Color: Clear, blue, white, black-white, or printed
- Thickness: 30-100 um, typical factory test range
- Adhesive: Low or medium tack pressure-sensitive adhesive
- Width: Custom slit width, +/-1 mm typical tolerance
- Surface Use: Stainless steel, PCM/VCM, glass, and plastic panels
-
Protective film for painted sheet goods should be selected around the full processing route, not from film thickness or initial tack alone. Pre-painted steel, coated aluminum, PCM/VCM panels, roofing sheet, cladding and other finished metal can be exposed to scratches, trapped particles, edge lifting, wrinkles, adhesive transfer and visible surface marking during slitting, punching, bending, roll forming, stamping, storage and shipment. A reliable approval plan starts with the actual coating and finish, then checks application conditions, deformation severity, dwell time and removal stage. Sample testing and a production-representative trial are recommended before full use.
-
- Material: PE or PET-based
- Color: Clear, blue, or milky white
- Adhesion: Low to medium tack
- Thickness: 30–100 microns
- Supply Form: Roll, sheet, slit roll, or die-cut
- Use Stage: Printing to final assembly
-
PET film puncture resistance describes how a defined PET or PET-based construction responds to localized penetration. This technical data compares puncture force, penetration distance, energy, and failure behavior for bare, treated, coated, and adhesive-backed PET films. Results support grade or lot comparison only when the tested structure, probe setup, and conditions are identified. Sample testing remains necessary before full use.
