No products were found matching your selection.
Other Related Products
-
Protective film for painted sheet goods should be selected around the full processing route, not from film thickness or initial tack alone. Pre-painted steel, coated aluminum, PCM/VCM panels, roofing sheet, cladding and other finished metal can be exposed to scratches, trapped particles, edge lifting, wrinkles, adhesive transfer and visible surface marking during slitting, punching, bending, roll forming, stamping, storage and shipment. A reliable approval plan starts with the actual coating and finish, then checks application conditions, deformation severity, dwell time and removal stage. Sample testing and a production-representative trial are recommended before full use.
-
- Material: PET film with double side silicone coating
- Typical Thickness: 25 um, 36 um, 50 um, 75 um, 100 um
- Color Options: Clear, milky white, blue, red, or matte finish
- Release Design: Equal release or differential release liner
- Common Width: 300-1600 mm, slit roll available
- Main Use: Tape, label stock, foam tape, and die-cut liner
-
Protective lens film for spray booths is used as a replaceable transparent layer over a viewing window so paint overspray, dry spray, dust, and routine wiping contact the film before they reach the clear substrate. This guide is intended for glass, coated glass, acrylic, and polycarbonate observation panels used in automotive refinishing and industrial coating areas. The main risks are reduced visibility, trapped contamination, edge lifting, adhesive transfer, film tearing, and an unverified removal interval. Selection should be based on the actual window material, coating condition, optical requirement, booth temperature, cleaning method, vertical holding need, and a sample test that continues through the planned service period.
-
- Material: PE film with pressure-sensitive adhesive
- Thickness: 30 um-120 um, selected by process risk
- Width: 50 mm-1600 mm, custom slitting available
- Roll length: 100 m-1000 m, grade dependent
- Surfaces: coated metal, stainless steel, aluminum
- Use: fabrication, forming, assembly, stacking, internal transport
-
- Material: PET polyester film with pressure-sensitive adhesive
- Typical film thickness: 25 / 36 / 50 / 75 / 100 microns
- Adhesive options: acrylic or silicone
- Color options: clear, blue, milky, matte black, or custom
- Supply form: log rolls, slit rolls, sheets, or die-cut pieces
- Common uses: insulation, masking, surface protection, lamination, and converting
-
- Product Type: Optical-grade OCA bonding film
- Adhesive Layer: Clear double sided adhesive layer
- Common Thickness: 50um, 100um, 125um, 175um, 250um
- Appearance: Transparent, low haze, high clarity
- Liner: PET release liner, easy release and tight release options
- Main Use: Display bonding, glass bonding, optical component assembly
-
- Material: PVC decorative vinyl with adhesive backing
- Finish: wood grain, matte, gloss, high gloss, solid color
- Width: 600mm, 1220mm, 1240mm, or custom
- Roll length: 30m, 50m, 100m, or bulk roll
- Surfaces: sealed MDF, laminated board, plywood, painted furniture panels
- Supply: roll, cut sheet, sample swatch, color-matched batch
-
- Material: PE film
- Adhesive: acrylic-based
- Colors: clear, blue, white, black & white
- Thickness: 30–80 mic typical
- Width: 1000–1500 mm common
- Use: processing to installation
-
PET film puncture resistance describes how a defined PET or PET-based construction responds to localized penetration. This technical data compares puncture force, penetration distance, energy, and failure behavior for bare, treated, coated, and adhesive-backed PET films. Results support grade or lot comparison only when the tested structure, probe setup, and conditions are identified. Sample testing remains necessary before full use.
